ABS sensor failure/repair

Answerprancer | 22:22 Mon 18th Jun 2012 | Motoring

4 Answers

My otherwise wonderful and fun-to-drive Ford Puma recently failed its MOT on ABS/TC (warning lights lit up on the dashboard). I just spent half a day sorting it out. I tested the impedance on the connectors and found out which sensor had failed.
The bolt that held the suspect sensor in place was seized so it had to be smashed to bits to remove it.
I went to Euro Car Parts for a replacement, put it in, took the car for a drive to get the 'self test' to kick in. It all worked.
To turn this into a question: does anyone else have any Ford Puma (or related) ABS sensor failure questions they would like to ask ? :-)

Mileage

Making Our Roads Safer

Answers

1 to 4 of 4

Best Answer

No best answer has yet been selected by Answerprancer. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.

malagabob

What are the steps to checking the impedance of sensors? Ignition on/off what meter, what setting.

tonyav

Well done, ABS sensors are a pain in the butt.

Answerprancer

Question Author

Hi Bob - you unplug the sensor and check the *other* end - ie. the plug that leads to the actual sensor, so it doesn't make any difference if the ignition is on or off. You set the multi-meter to OHMS and touch the prongs onto the two terminals of the plug. The impedance is supposed to be around 1.1K/Ohms for my car, it may be different for others (you'd have to find the figure for a particular car).
Thanks Tony - yes it was.