Donate SIGN UP

A couple of little bits of help for a Mazda 6

Avatar Image
bobjugs12 | 09:00 Tue 04th May 2010 | Cars
6 Answers
Hey folks,

Gearchanging in my Mazda has become very stiff and clunky. It can be quite difficult to change gear at times.
I want to eliminate the easy options first before I start worrying about new clutches etc, so I'm gonna top up the gearbox oil. However I have no idea how to do it on this car. Any suggestions?

Also, any idea how to get a paintcode for my car if it's not in the handbook or on the chassis anywhere? It's the dark blue you see on Mazda 6s but the Halfords list doesn't mention it.

Cheers folks
Gravatar

Answers

1 to 6 of 6rss feed

Best Answer

No best answer has yet been selected by bobjugs12. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.
Bob
You need to check the gearshift linkage from th remote underneath .. to the gearbox input. Check for wear in and connection, too. These are often nylon .. If worn, you may need to change part.
Transmission: A lot of Japanese cars have a drain point but no refill/level plug. I don't have a munual for that transmission, but you need to loog at the forward face of gearbox for a hex or allem key plug. If fitted, this will be the level to fill to.
They regard transmissions nowadays as "filled for life" lol ..
In this case, you can only fill through any gap into gearbox (like speedo drive plug or driveshaft socket. You have to remove bits for that!)
Have a look first! : )
Check for a sticker on boot inside panel.
Should be with VIN normally, like a letter and number.
If you want touching up : ) .. go on ebay and order a touch up from one of the sellers there. Cost you £8 ish for two parts (base and lacquer)
Question Author
Cheer albags. I'll get the overalls and jack out over the weekend :)

As for the touching up, it's tempting but i think i'll decline ;)
Check the fluid level in the hydraulic clutch ( I'm assuming it's hydraulic seems likely)

If it's low you may have a leak - unfortunately if that's the case it's most likely the slave cylinder on the way out.

But at least it's quick to check the fluid level
lol Bob .. That makes two of us then.
I C U have enough to handle on another thread : )
Cheers.
-- answer removed --

1 to 6 of 6rss feed

Do you know the answer?

A couple of little bits of help for a Mazda 6

Answer Question >>

Related Questions

Sorry, we can't find any related questions. Try using the search bar at the top of the page to search for some keywords, or choose a topic and submit your own question.