Donate SIGN UP

Corsa Wipers

Avatar Image
max1958 | 20:45 Wed 20th Mar 2013 | Motoring
4 Answers
wipers will not stay in park when wiper stork is off motor seems ok wipers are pointing up when off.cheers all.
Gravatar

Answers

1 to 4 of 4rss feed

Avatar Image
Found this: Had exactly the same problem on my son's Corsa C. Wipers don't park on intermittent. Checked the wiring / relays out. Easiest way to check this out without having to open the body control module is at the wiper motor connector where it goes onto the motor. This is a five pin connector labelled A through to E. A is the yellow wire nearest to the offside of...
00:04 Thu 21st Mar 2013
Have you changed the wiper arms recently? Possibility is they have been refitted incorrectly. Do they always stop in the same position?
Found this:

Had exactly the same problem on my son's Corsa C. Wipers don't park on intermittent. Checked the wiring / relays out. Easiest way to check this out without having to open the body control module is at the wiper motor connector where it goes onto the motor. This is a five pin connector labelled A through to E. A is the yellow wire nearest to the offside of the car, and the others follow on in order. The important one to check for self parking is pin D. This should have a permanent +12V feed. If it has, (as ours did), it proves the wiring and relays are OK. Next I removed the motor / linkage assembly. Once this is off the car, there are three small torx headed screws on the motor case. Remove these and carefully and evenly prise off the cover plate. There are several plastic rivets also holding this but they will release if you are careful. Inside the cover plate you will see three copper fingers. The self park circuit is controlled by the two furthest from the centre of the motor. What happens is these fingers lose their tension and don't make a reliable connection with the round disc below. You may even spot signs of arcing, (a black deposit), on the cover plate just above the outermost contact. On the circular metal disc, on the outer edge will be a notch which is infilled with a nylon piece, (you may need to clear away the grease to see fully). On our motor there was a burn mark where the contact had been arcing. Clean this away. Carefully bend the copper fingers down away from the plate so that they now make a reliable connection on the circular disc when the cover is replaced. Repack with grease and if required use a sealant such as hylomar before replacing the cover plate and the screws. Refit the motor and linkage and you should be in business!

http://www.allcorsa.co.uk/forums/showthread.php/windscreen-wiper-problem-25736.html?s=e4b8991e99422b5fabd47c2b21f9dfa0&
Could just be dust from the stork's feathers though, probably better off in a zoo than kept in a hatchback. :)
I had the same problem with an Astra and a Vectra, both times it was fixed under warranty. There is a cam in the wiper motor that should keep the power on to the motor until the wipers are back in the parked position. This seems to be an increasing issue as motor manufacturers outsource to the cheapest bidders as I also see this a lot in Fiats driving around with wipers parked in the middle of the screen, and a colleague has the same problem with his Mondeo. The automotive market is obviously flooded with cheap tat made for tuppence ha'penny in India or China, and when you need to buy a replacement if your warranty has run out you're stung for four hundred notes. That is what the parts came to on the invoice that I saw for the Astra before it went to the warranty provider.

1 to 4 of 4rss feed

Do you know the answer?

Corsa Wipers

Answer Question >>