Possible Airlock On Cold Water System

sparkymick | 16:40 Wed 06th Oct 2021 | Home & Garden

9 Answers

turned stopcock to change washer on bath cold tap. It didnt stop the water so it must be fed from cold water tank in loft. I let it drain. changed the washer and turned stopcock on to fill tank. trouble is no water supply at the tap. Been up to check cold water tank (there are two one large and one small) and its full but no pressure at bath tap. anyone any ideas. Air lock possilbe. thank you.

Artex

Problem With Riser Bar On Shower

Answers

1 to 9 of 9

Best Answer

No best answer has yet been selected by sparkymick. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.

The Builder

Old-fashioned low-tech solution Mick.

Open tap fully
Put gob over spigot
Blow.

Worth a shot ;o)

Ryzen

If you have a hose, fit it on a mains fed tap and then onto the tank fed cold tap.This will force the air lock out.

youngmafbog

Possibly is an air trap. As the bath is fed by the cold water tank possibly the lavvy and sink are also fed by it. Are they working?

Not sure on your pipes. One large likely to be cold feed the other the hot feed. Small?? possibly a shower?

youngmafbog

Have you ever tried that Ryzen? Usually you get a free shower in the process! But worth a shot.

sparkymick

Question Author

tried blowing with all my might to no avail ! original problem was very poor flow rate and i assumed that a washer would fix it. now it is still very poor flow rate so maybe another problem. what concerns me is that when i took the valve part of the tap out there was ample flow until the tank emptied. now tank full there is still very poor flow when valve removed. confused

Ryzen

ymb 16:47...yes, you need to make sure both ends are well secured...:-)

The Builder

Either a sticky washer (not leaving the seat properly.)
Or... the valve is stuck (as you wind the handwheel fully open... it's leaving the bit with the washer behind.)
Bit difficult to put into words. Take the valve off and check it's going up and down properly when wound.

The Builder

Hang on.. now I'm confused. Sorry.
You've got the valve out but flow is not good?

If not an airlock, then it may be a partial blockage in the feed from the tank. Roof tanks are notorious for containing rubbish of all sorts.

Atheist

Possible decomposing pigeon or rat?

1 to 9 of 9

Do you know the answer?