1 to 15 of 15

What would be a cost of decorating a bathroom, new bathroom suite, tiles and floor tiles (if everything was bought already) so just the cost of instaling and decorating and taking out old bath, toilet...
Hi I'm looking to paint the brass fire trim in my gas fire Matt black. What paint would you recommend please?
We had a leaking roof which led to a few areas of hygroscopic salts leaching through the plaster. The leaking roof has now been fixed, we have a dehumidifier running in the room and the wall is drying...
I'm about to fit a new WC in our ground floor toilet where room is limited . The problem I have is where the 100mm waste pipe comes out of the floor it doesn't leave me a lot of room to make a decent...
Has anyone swapped from British Gas to SSE. I have a British Gas smart meter which I realise will not communicate with SSE but does the monitor still function to allow me to see usage....
Ages ago I bought one of the above (mounted on your forehead)But it won't light up,I've looked inside is it supposed to have batteries inside and what type please? Thanks.
I need something to put on the feet of my wooden foot rest to stop it slipping on the carpet. Has anyone any ideas please? ,hollytree...
My NEFF integrated cooker hood is fine, except that it's impossible to get inside it to give it a thorough clean. You can take off the filter assembly, and clean that, but the fans, etc., are sealed...
Hey, i've sanded down my skirting boards to what i think is the orignial undercoat, will i have to redo the undercoat before painting, or can i just gloss them stright away?...
hey, does anyone know if these two different spay paints will be the same colour. One is a matt black and the other is a satin black, i don't need them to be the exact same colour but i'm not sure if...
I have just fitted a Basin Mate seal to stop a leak. My problem is I cannot tighten the black locking nut sufficiently. I have tried a Mole Wrench but it is chewing the plastic nut. Is here a special...
I'm looking to change a small central htg radiator ,but have a problem with a valve spindle ,the problem being that when I close the valve I get a small dribble of water through the spindle which gets...
I have four very orange pine chairs. I stripped one with a hand sander but it took so long and the sander is a bit brutal to be honest. Any suggestions as to how I can make things easier and quicker?
My gas boiler stopped working last Wednesday (9th Nov). An engineer called out to investigate and seemed taken aback by what he found inside. He said he hadn't come across this issue in all his time...
I need to make 0.5 cubic metres of concrete mixing ratio 1 cement 2 sands and 3 chippings how many bags of each do i need to purchase

1 to 15 of 15

Latest posts