Donate SIGN UP

Calling all Plumbers

Avatar Image
BigDogsWang | 14:11 Tue 14th Feb 2006 | Home & Garden
3 Answers

I recently moved into a 4 year old house. It has three floors, a downstairs toilet, a bathroom and toilet on the middle floor and a en-suite / toilet on the top floor. We notice than after flushing the toilet upstairs, the flush stops fairly quickly (it does the job). However, after about 10 seconds, its starts filling the bowl with water again, which continues for a good 20 seconds (which seems totally unnecessary). Also, the shower continues to sporadically dribble water for long periods of time, a few minutes after you have finished using it. All of the water pressure in the house seems to be VERY powerful, including (unusually) the hot water taps.
Is the cause for the toilet / shower continuing after use? If so, is there any way of turning it down?

Gravatar

Answers

1 to 3 of 3rss feed

Best Answer

No best answer has yet been selected by BigDogsWang. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.
you need to place a regulator on the cold water main and the hot water feed from the hot water tank. Is the toilet adjustable within the syphon? (Also is it a push button or a handle flush?) From the shower is it cold or hot water? If it is cold water, then putting a regulator on the cold water main will eliminate this. My hubby says he will sort it all out for �50 if you are local to Sussex!! lol
Question Author

Thanks for the advice. To be honest I haven't really looked at any of it, I was just hoping for some possible pointers before getting my spanners out. At least now I'll know where to begin.


Thanks.


P.S. Bedfordshire I'm afraid :)

You probably are lucky enough to have a modern mains hot water system. The toilet sounds as if it just wants the water level adjusting, there is an adjustable nut. You should have a service valve near all taps which can be turned down to reduce the flow. If the shower mixer is turning off ok then the problem will not be the pressure.


This dribbling is common on overhead shower feeds where the water slowly drains out of the pipe and can be cured by fitting a non return valve behind the shower rose. Your hot water should already have a pressure reducing valve to protect the cylinder but if your cold water is much above 4 - 5 bar then it would pay to have another one fitted.

1 to 3 of 3rss feed

Do you know the answer?

Calling all Plumbers

Answer Question >>