Performance Scroll Saw 16" 405mm

dopeydiner | 12:04 Tue 10th Jul 2007 | DIY

2 Answers

Hi Can u help me. The blade on my scroll saw is not 90deg. vertical and is running (Top to Bottom) Left to Right. Blade holders are lined-up correctly. How do I adjust to bring it back to 90degrees vertical?

Fine Cut

Replacing sealant behind mixer taps

Answers

1 to 2 of 2

Best Answer

No best answer has yet been selected by dopeydiner. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.

mrpeter

Hi dopeydiner, are you sure that it is the blade out of alignment and not the bed of the saw. There should be some form of adjustment for the bed to be set at so that you can cut at different angles. Perhaps the bed has moved and needs resetting.The bed usually rotates right and left when looked at from the front. and is held in place by a nut underneath. Hope this helps.

dopeydiner

Question Author

Thank you mrpeter for reply. I shall go and try that. Regards

1 to 2 of 2

Do you know the answer?