Blind Pulls

[Hardatit42]

Looking for a four cord collector that has a one cord pull

[alavahalf]

The wife has often made Roman blinds .. these can have any amount of collector cords depending on the width.
But once the blinds are fitted, the cords all get platted together leaving you with one cord to raise and lower the blinds.
The cords are cut to length when making the blinds, wouldn't imagine they are the sort of thing you would buy and fit after.

[Hardatit42]

Thanks for reply alavahalf.
We already have a four hole cord collector that gathers the cords together with a single cord down to a pull.
This in place when the blinds are completely down, which means the collector is fitted about 200mm from the cord aperture, but when pulled up fully the four cords show. This was fitted by a blind company who say they cannot get them !

[TonyV]

Bit difficult Hardtit42 what is approx diameter of cord you are looking for 1mm or less than that.

[Mamyalynne]

One shown here taking 3 cords, may be worth checking if that company also do one that would suit your requirements.

https://www.the-millshop-online.co.uk/curtain-lining-heading-tape/roman-blind-rods/blind-pull.html

[Hardatit42]

Have gone with Mammylyne, in a fingers crossed situation. It seems that blinds etc are a closed shop and very limited in the spares division. Mill house were willing to listen, however the online pic shows 4 holes but helpful telephone saleswoman said it was 4 into 1 hole.
Will let you know.