13A Cable Termination

Aeolus | 13:04 Mon 15th Oct 2018 | Technology

13 Answers

Does anyone know where I can purchase the little copper crimps that are used by manufacturers to terminate the wires in a 13A plug?
I have searched for crimps, ferrells, oversleeves etc. but come up empty.
Please; I want to use these so lets not get into the "to tin or not to tin" debate.
If you know where I can buy them a link would be marvellous.
Thank you for reading this.

Browser.

Do You Know Any Alternative Question And Answer Sites?

Answers

1 to 13 of 13

alavahalf

Best Answer

I wont ask why you would want to fit a ferrule within a 13A plug. But you could always make your own if they are that important .. https://tinyurl.com/y9tpy9qo

14:01 Mon 15th Oct 2018

Go To Best Answer

MichaelZZ

Try eBay but spell ferrule correctly!
If you only want a few try a friendly electrician.

derek-33

why ? i never use crimps just keep the bare wire to around 3/8" and twist it round so its uniform,never done anything but this all my many decades

TheChair

The only reason they're used on commercially fitted plugs is to make mass production simpler.

donny48

https://www.ebay.co.uk/itm/100-x-Pin-Crimp-Insulated-Terminal-Connectors-for-Electrical-Cable-/232086962607

alavahalf

I wont ask why you would want to fit a ferrule within a 13A plug. But you could always make your own if they are that important ..
https://tinyurl.com/y9tpy9qo

Aeolus

Question Author

MichaelZZ: I have and I did; got it wrong here though. Thanks for the advise though.

derek-33: I did say no discussion I just want to! I've been in avionics engineering for over 65 years.

TheChair: I know, it makes it easier for me as well.

donny48: Nice try but these are what I kept ending up with. Good to see you here as well as in Quizzes.....

alavahalf: Thanks for not asking and the link was another good try. I shall make my own from the .5mm copper sheet on your suggested link; which gets you a best answer.