Donate SIGN UP

How Do I Calculate The Shape To Trace Out?

Avatar Image
Fanriffic | 14:55 Sun 25th Jun 2017 | How it Works
5 Answers
I have a terracotta plant pot that I want to cover / wrap with paper so the paper is flush round the whole outside surface.
The top of the plant pot is wider than the bottom so obviously a rectangular shape doesn’t fit the shape. It needs to be a curved shape to fit correctly.
How do I calculate the shape to trace out the cutting area on the poster design I want to wrap around the plant pot?
Diameter of pot is 12 inches at the top and 8 inches at the bottom.
Gravatar

Answers

1 to 5 of 5rss feed

Avatar Image
get a large sheet of any kind of paper that is bigger than the pot. Lay the pot down on the paper and mark it at top and bottom, draw a line between the two marks and make a mark up the side of the pot. lay the mark on the pot against the mark on the paper and roll the pot across the paper until the mark on the pot touches the paper again. mark top and bottom of the pot and draw a...
15:05 Sun 25th Jun 2017
get a large sheet of any kind of paper that is bigger than the pot. Lay the pot down on the paper and mark it at top and bottom, draw a line between the two marks and make a mark up the side of the pot. lay the mark on the pot against the mark on the paper and roll the pot across the paper until the mark on the pot touches the paper again. mark top and bottom of the pot and draw a line between. Then cut the pattern out roughly leaving it much bigger than the two marked lines and allow a little overlap at the two marked lines. Wrap the pattern around the pot and fasten it temporarily. You should now be able to mark or trim the paper to make a neat finish at top and bottom, if it was me I would leave some extra to tuck underneath to make a neat finish and some to tuck inside the pot as well. When you are happy with the pattern, cut it out of your patterned paper.
Question Author
Good thinking woofgang - didn't think about rolling over the paper to mark the points. I was thinking that I would have to do loads of boring maths and start getting out my protractors and compass. I'll give it a go later to see if it works for me. Many thanks.
you are welcome :) I like to do stuff like this and I don’t “do” maths
Question Author
It worked a treat. Plant pot now has a new paper wrap design.
I found it helpful to tape the paper down on to the table to stop it moving when rolling the plant pot and marking the points and tracing out the cutting pattern shape. Thanks again woofgang.
you are most welcome Fanriffic

1 to 5 of 5rss feed

Do you know the answer?

How Do I Calculate The Shape To Trace Out?

Answer Question >>

Related Questions

Sorry, we can't find any related questions. Try using the search bar at the top of the page to search for some keywords, or choose a topic and submit your own question.